Recent Posts

  • Hi team,

    Any one have experience in Altium schematic designing.
    I am facing some issue in Hierarchy->harness in Schematic.
    The offpage number for harness is not showing, and while generation the smart PDF if we click the harness port /green box the page want to go there automatically, but that also not working.

    read more
  • D

    @salmanfaris thank you so much man, I'll try this and update you shortly. Thank you once again.

    Best,
    Dipu

    read more
  • Hi @dipu_varghese ,

    Here is the sample input from the binary edge impulse inference,

    Predictions (DSP: 16 ms., Classification: 1 ms., Anomaly: 2 ms.): idle: 0.91016 snake: 0.08203 updown: 0.00391 wave: 0.00391 anomaly score: -0.067โ€

    And from here for example we can try to get the updown values only by attaching the device to another controller and read the Serial string directly.

    void setup() { // Start serial communication at 9600 baud Serial.begin(9600); } void loop() { // Wait until there is data available on the serial port while (!Serial.available()) { // Do nothing } // Read the input string from the serial port String inputString = Serial.readStringUntil('\n'); // Find the position of the "updown" value in the input string int updownPos = inputString.indexOf("updown:"); // If the "updown" value was found in the input string if (updownPos >= 0) { // Extract the "updown" value from the input string String updownString = inputString.substring(updownPos + 8, inputString.indexOf('\n', updownPos)); // Convert the "updown" value to a float float updownValue = updownString.toFloat(); // Output the "updown" value Serial.println(updownValue); } }

    The sketch should then output the "updown" value, which is 0.08203.

    Hope this will be helpful, let me know if you need more clarification.

    read more
  • D

    @salmanfaris any updates?

    Best,
    Dipu

    read more
  • D

    @salmanfaris Hope you're doing well, did you get sometime to work on this?

    Best,
    Dipu

    read more