@kowshik1729 thank you for replay

@salmanfaris click this pdf

Hi team,

Any one have experience in Altium schematic designing.
I am facing some issue in Hierarchy->harness in Schematic.
The offpage number for harness is not showing, and while generation the smart PDF if we click the harness port /green box the page want to go there automatically, but that also not working.

@kowshik1729 ok

The above image shows the ckt with ultrasonic sensor and attiny 45 Ic ,Bd 140 transistor (for switching the 6v pump).
***The problem is when I give power from 5v regulator to all this as shown in fig, the circuit is not working ,(not enough power ).
What should I do.
Should I give separate power to motor
I am using 5.5v adaptor 500mAh.

*I have checked the circuit by connection separate 5 v from arduino ,to that attiny 45 ic and sensor,. Then it is working .

• Please help

@salmanfaris
No

@kowshik1729 ok

I want to make a device which measure the level or quantity of soil deposited under a tank containing water (sedimentation). Any one help please.

@kowshik1729 thank you

@kowshik1729 this link also include data sheet link

@kowshik1729 I just find that hc05 is not getting much ampere(current) from that battery.
That is the main problem .
Amps
What to do

@kowshik1729 I wish to use led in series because I want the all circuit so small .
To make a key finder device .
My hc05 didn't burn out it was working when I connected it to arduino 5v after that.