Hi team,
Any one have experience in Altium schematic designing.
I am facing some issue in Hierarchy->harness in Schematic.
The offpage number for harness is not showing, and while generation the smart PDF if we click the harness port /green box the page want to go there automatically, but that also not working.
The above image shows the ckt with ultrasonic sensor and attiny 45 Ic ,Bd 140 transistor (for switching the 6v pump).
***The problem is when I give power from 5v regulator to all this as shown in fig, the circuit is not working ,(not enough power ).
What should I do.
Should I give separate power to motor
I am using 5.5v adaptor 500mAh.
*I have checked the circuit by connection separate 5 v from arduino ,to that attiny 45 ic and sensor,. Then it is working .
I want to make a device which measure the level or quantity of soil deposited under a tank containing water (sedimentation). Any one help please.
@kowshik1729 this link also include data sheet link
@kowshik1729 I just find that hc05 is not getting much ampere(current) from that battery.
That is the main problem .
Amps
What to do
@kowshik1729 I wish to use led in series because I want the all circuit so small .
To make a key finder device .
My hc05 didn't burn out it was working when I connected it to arduino 5v after that.