PCB Design for ESP32 Stand alone module

[Sharmila]

And having one more doubt !
Bootloader for esp32 will present already or we need to load the bootloader code into the newly brought esp32 chip ?

[kowshik1729]

@Sharmila If you're programming the board for the first time using Arduino IDE then you need to burn the bootloader into the bare IC. I have a doubt when you said the IC is not getting programmed even though the GPIO0 is low.

I wanna know is GPIO0 low all the time or did you pull it low momentarily using a button??

[Sharmila]

@kowshik1729 Yes i m programming the board first time using arduion. GPIO 0 is low all the time.

[kowshik1729]

@Sharmila GPIO0 must not be low all the time. It must be held low only for a moment. Because GPIO0 is a boot strap option for choosing between UART download and normal operation. Please refer to the datasheet and search boot strap. And also can you please post a snap of your newly designed board please?

[Sharmila]

@kowshik1729 thank you for the hint ! i will check it . schematic picture of my board is given below

()

[Sharmila]

@kowshik1729 sorry, gpio 0 is low only till it is programmed. after that this will disconnected.

[kowshik1729]

@Sharmila Reviewed your schematics. Have the following doubts

1. Is this a USB receptacle?

2. Didn't find any option where you can pull the GPIO0 low and bring it back to normal state. Did you have a jumper connection or button between GPIO0 and GND?

[Sharmila]

1. no.
2. we are using jumper for gpio 0th pin. please refer the below image.
   

[saheen_palayi]

This post is deleted!