How to define angle for 995 360deg continuous servo?
In the 995 datasheet , angular velocity = 0.17s/60 Deg (5 volt)
:= 180 deg = 0.51s But practically I’m getting 805s
And other angles are as follows (irl)
425s = 90deg
805s = 180deg
1130s = 270deg
1475s = 360deg
I want to know why it’s not consistent and (if it’s not a mistake of mine) could I get a formula for the time to degree
Thanks for your time :blush:
kowshik1729 last edited by
@hydro-bob Can you post the details of servo like datasheet of the servo you're using?
It’s normal mg 995 servo
salmanfaris last edited by
Hi @hydro-bob , did find the solution?
Curious to know how the social media giant went down for an unusual time?
Read this article by Cloudflare explaining how complex the internals of the Internet is and what happened to Facebook and its affiliated services.
#facebookdown #WhatsAppDown #Instagramdown #socialmedia
Developing Android Applications with Eclipse is a bit old way. Few eclipse enthusiasts might be doing it still though. For your issue, check all the environment variables related to SDK and Emulators are correctly configured.
If you're a beginner and no specific reason to use Eclipse, try to start with AndroidStudio.
@rahuleapen Can you please share the connection diagram?
Arduino has been compiled to run a motor pump. The pump seems to be working fine via the 5v and ground port with appropriate voltage and current. The same voltage and current is seen across the gpio whenever turned high but the motor doesn't run via gpio. Can anyone help me out here..please it's urgent
@rosetoby Thanks for sharing, can you post your queries with details, code snippet ..etc