How to define angle for 995 360deg continuous servo?
-
In the 995 datasheet , angular velocity = 0.17s/60 Deg (5 volt)
:= 180 deg = 0.51s But practically I’m getting 805s
And other angles are as follows (irl)
425s = 90deg
805s = 180deg
1130s = 270deg
1475s = 360degI want to know why it’s not consistent and (if it’s not a mistake of mine) could I get a formula for the time to degree
Thanks for your time
-
@hydro-bob Can you post the details of servo like datasheet of the servo you're using?
-
It’s normal mg 995 servo
-
Hi @hydro-bob , did find the solution?
Recent Posts
-
@zainmuhammed Can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
You can put the GPS value on top of the loop or setup function.
Also, what kind of gateway are you using? Is it configured okay, OTA is done?
-
@salmanfaris Today I tried after connecting a 18650 cell,
Data getting in console after integration of both lora and gps.
here you can see that GPS value is 0,0. also in my previous post you can see that GPS value is not reading.
Also the status LED is active after it is connected to the satellite. -
Hi @zainmuhammed ,
Can you share the GPS and LoRa output when it’s working?
Also can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
Also make sure the device provides have enough to modules. The GPS need more power when you cold start.