DTDS-622C MEVB Lora modam programing
-
@sarathslab said in DTDS-622C MEVB Lora modam programing:
DTDS-622-MEVB
Hi @sarathslab ,
Thanks for asking on MakerGram Community Forum!
Is this is the one you're using?
https://dtdsgp.com/lora-module/ -
@swalahamani yes
-
@sarathslab Did you check the documentation?
If not please check those first and post the issues or blockers you're facing while doing it here.
-
@zainmuhammed @salmanfaris You may be able to help with this.
-
@sarathslab why your are choosing this perticular LoRa module, can you please elaborate your use case. Personally I don't have experience with this module. When i go through the details of this hardware find like this is a UART device and so you can communicate by using the AT comments. And this will be available on the datasheet I guess. Also if you don't want to use this perticular module I suggest sx1276 or LoRa E5 from Seeedstudio. And by using this you can able to connect with helium network or things network. If you want to know more about this I think Salman can help.
Recent Posts
-
@Vishnuraj2003 Are you able to fix it?
-
Hi @Vishnuraj2003 ,
As per the documentation, I think we only route the data over the LoRa oR BT. The Wifi is used for sniffing access points for better geo-location and positioning along with GPS.
And what is the issue you facing when connecting the tracker with gateway? Double check the FREQ on both node and gateway configuration
-
I'm working with Seeed Studio's Wio Tracker 1110 Dev Board. According to Seeed Studio's documentation, we can use the Wi-Fi antenna inside the Wio Tracker to send data. However, when I used the Sensecraft app, it shows that the board is offline. I have tried connecting it to the Sensecap M2 Gateway but couldn't do it due to a lack of documentation. Please share any advice or resources that could help. Thank you.
-
@binishmatheww All the best. Let us know if you need any help.
-
@salmanfaris thanks a lot.
