I am trying to set up a janus webrtc to stream an RTSP to an HTML page.
I have followed the getting-started steps by Janus-gateway official github repo.
Since I am new to web development. I do not understand how to host the Webrtc server. can anyone guide me to set up an HTML page that can display a video stream from an RTSP server using janus webrtc?
@Richu-Bini am using an Arduino uno as ttl module
Showing this message from serial monitor .... i have used an arduino as a TTL module by shorting the GND and reset pin
when i tried to upload the code it is showing this error
This is the schematic i used
@Richu-Bini sry guys its my fault i forget to put 'a' in int main (void) 
.... 2 days to find an 'a'
I try to program atmega328p using vscode the extension i used is avr helper ... In avr helper when i try to build the code it is showing
`
1 task in folder intrrepts: make -f/home/pi/Documents/intrrepts/.vscode/avr.targets.mk build <
===== Making .vscode/avr.build/output.elf
/usr/lib/gcc/avr/5.4.0/../../../avr/lib/avr5/crtatmega328p.o:(.init9+0x0): undefined reference to `main'
collect2: error: ld returned 1 exit status
make: *** [/home/pi/Documents/intrrepts/.vscode/avr.targets.mk:52: .vscode/avr.build/output.elf] Error 1
The terminal process "/bin/bash '-c', 'make -f/home/pi/Documents/intrrepts/.vscode/avr.targets.mk build'" terminated with exit code: 2.
Terminal will be reused by tasks, press any key to close it.
`
i think this is the problem with avr-gcc can anyone help to solve this
while learning the USART communication in avr setting baud rate part seems little confusing to me .
There are two registers for setting baud rate UBRROH AND UBBRROL
How Can i use these registers...?
What is the difference between hardware pwm and software pwm