Android programming using ECLIPSE Ide & android sdk
-
I have been facing this problem recently while I run the program the output terminal just shows scanned text and the android virtual device is not opening. I have reinstalled the SDK but the problem still persist.!
Bazil Nizam
Front-End Web Dev, UI/Ux Designer
+91 9895 094 299
bazil4u@gmail.com
twitter.com/BazilNIzam -
@bazil-nizam
Developing Android Applications with Eclipse is a bit old way. Few eclipse enthusiasts might be doing it still though. For your issue, check all the environment variables related to SDK and Emulators are correctly configured.If you're a beginner and no specific reason to use Eclipse, try to start with AndroidStudio.
Recent Posts
-
Hi team,
Any one have experience in Altium schematic designing.
I am facing some issue in Hierarchy->harness in Schematic.
The offpage number for harness is not showing, and while generation the smart PDF if we click the harness port /green box the page want to go there automatically, but that also not working. -
Hi @dipu_varghese ,
Here is the sample input from the binary edge impulse inference,
Predictions (DSP: 16 ms., Classification: 1 ms., Anomaly: 2 ms.): idle: 0.91016 snake: 0.08203 updown: 0.00391 wave: 0.00391 anomaly score: -0.067”And from here for example we can try to get the updown values only by attaching the device to another controller and read the Serial string directly.
void setup() { // Start serial communication at 9600 baud Serial.begin(9600); } void loop() { // Wait until there is data available on the serial port while (!Serial.available()) { // Do nothing } // Read the input string from the serial port String inputString = Serial.readStringUntil('\n'); // Find the position of the "updown" value in the input string int updownPos = inputString.indexOf("updown:"); // If the "updown" value was found in the input string if (updownPos >= 0) { // Extract the "updown" value from the input string String updownString = inputString.substring(updownPos + 8, inputString.indexOf('\n', updownPos)); // Convert the "updown" value to a float float updownValue = updownString.toFloat(); // Output the "updown" value Serial.println(updownValue); } }The sketch should then output the "updown" value, which is 0.08203.
Hope this will be helpful, let me know if you need more clarification.