GPS + RF433 Not working together.
-
@salmanfaris Not syntax error. its not reading GPS data. That's the problem.
-
What output you are getting? Just some zeros?
-
@salmanfaris No any output. Arduino not wating for GPS data.Not runing this loop
while (gps.available( gps_port )) -
does it return one/true when you are testing only with gps and gps.available( gps_port )?
-
@salmanfaris gps.available( gps_port ) Is not return a True case.
-
@salmanfaris for running
while(gps.avaible());MCU need to wait some time. but after adding VirtualWire library it's not waiting for Serial.available() -
@rafitc99 said in GPS + RF433 Not working together.:
ps.available( gps_port ) Is not return a True case.
Then how is the while loop will work? It should return!
-
@rafitc99 said in GPS + RF433 Not working together.:
library it's not waiting for Serial.available()
did you try manual waiting? Instead of delay, you can use mills, so the background works will keep run.
-
@salmanfaris said in GPS + RF433 Not working together.:
@rafitc99 said in GPS + RF433 Not working together.:
library it's not waiting for Serial.available()
did you try manual waiting? Instead of delay, you can use mills, so the background works will keep run.
Let me try.
-
did you try manual waiting? Instead of delay, you can use mills, so the background works will keep run.
Not working. Same problem.
Recent Posts
-
-
@codelery said in Help needed: Arduino Wireless Notice Board project:
I am using the hardware serial (pin 0 and 1 on Arduino Uno)
As @rafitc99 mentioned, you need to expand the Serila buffer, in the hardware serial also the Arduino board package implements a 64-byte ring buffer for send and receive on the hardware serial messages. So you need to change that to 256 as per your message length.
