CP2104-F03-GMR device descriptor request failed
-
Hi guys,
I have made a custom PCB with CP2104 USB TO UART Bridge. You can find the schematics realted to the USB below. After getting the PCB fabricated, when I plug into my computer it is showing as Device not recognized - Device Descriptor request failed. I tried lot of methods but no luck. Uninstalled the drivers using the instructions suggested in this thread . But nothing worked and i am using a Windows 10 PC. Please help me out with a correct solution.
The board is powering up properly. please someone suggest me a work-around...!! Thanks
-
Hi @kowshik1729 , The connection between the CP2104 and ESP01 seems looks ok, can you share a more clear picture of the Automatic IO, EN toggling Circuit. Also double-check the trace continuity with a multimeter too.
-
@salmanfaris oh no....the UART Bridge is not for the ESP-01. There is an ESP32-Wroom SoC, and yeah I shall share more info.
-
@kowshik1729 Okey, I come with conclusion from the right bottom side esp01.
-
@kowshik1729 Did you solve the issue?
-
Not yet @salmanfaris .
Recent Posts
-
@zainmuhammed Can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
You can put the GPS value on top of the loop or setup function.
Also, what kind of gateway are you using? Is it configured okay, OTA is done?
-
@salmanfaris Today I tried after connecting a 18650 cell,
Data getting in console after integration of both lora and gps.
here you can see that GPS value is 0,0. also in my previous post you can see that GPS value is not reading.
Also the status LED is active after it is connected to the satellite. -
Hi @zainmuhammed ,
Can you share the GPS and LoRa output when it’s working?
Also can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
Also make sure the device provides have enough to modules. The GPS need more power when you cold start.