Pump motor doesn't run via gpio
-
Arduino has been compiled to run a motor pump. The pump seems to be working fine via the 5v and ground port with appropriate voltage and current. The same voltage and current is seen across the gpio whenever turned high but the motor doesn't run via gpio. Can anyone help me out here..please it's urgent
-
@rahuleapen Can you please share the connection diagram?
Recent Posts
-
@zainmuhammed Can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
You can put the GPS value on top of the loop or setup function.
Also, what kind of gateway are you using? Is it configured okay, OTA is done?
-
@salmanfaris Today I tried after connecting a 18650 cell,
Data getting in console after integration of both lora and gps.
here you can see that GPS value is 0,0. also in my previous post you can see that GPS value is not reading.
Also the status LED is active after it is connected to the satellite. -
Hi @zainmuhammed ,
Can you share the GPS and LoRa output when it’s working?
Also can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
Also make sure the device provides have enough to modules. The GPS need more power when you cold start.