SMD Connectors for Inter board connections
-
@salmanfaris I'm looking for something very small and with less pin count(probably 4). Something like as shown below.
but I need a connecting wire that correctly fits these connectors. So, Can you suggest me a receptacle and wire pair?
-
@kowshik1729 But you need to stack the PCB on top another right?
If you need these type connector you can check Seeed Grove connector with grove cable or Sparkfun Qwiic with Qwiic cable
Seeed Grove
Sparkfun Qwiic
-
@salmanfaris No, I will not stack the PCBs on top of each other. I'll be daisy-chaining them, I guess the second picture which you kept is good but are those connectors SMD?
I need strictly SMD.
-
@kowshik1729 If you need to stack the PCB, then check the first comment I made all of them are SMD
@kowshik1729 said in SMD Connectors for Inter board connections:
Something like as shown below.
In the second comment you shown JST connector and that's a horizontal connector, you can't stack PCB vertically with that.
-
@salmanfaris Great. Can I know the manufacturer part number please? It would be easy for me to take my design to production easily.
-
@kowshik1729 Sure, I already mentioned that in the post itself, please check.
-
@kowshik1729 The Sparkfun Qwiic Connector Libray can be found in the Sparkfun Eagle library under SparkFun-Connectors.lbr->Qwiic Connector.
Recent Posts
-
@zainmuhammed Can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
You can put the GPS value on top of the loop or setup function.
Also, what kind of gateway are you using? Is it configured okay, OTA is done?
-
@salmanfaris Today I tried after connecting a 18650 cell,
Data getting in console after integration of both lora and gps.
here you can see that GPS value is 0,0. also in my previous post you can see that GPS value is not reading.
Also the status LED is active after it is connected to the satellite. -
Hi @zainmuhammed ,
Can you share the GPS and LoRa output when it’s working?
Also can try capturing the GPS when the device is starting the loop instead after joining the LoRaWAN and see?
Also make sure the device provides have enough to modules. The GPS need more power when you cold start.